how to start teamviewer from command line

If your Mac is using a firmware password, you're prompted to enter the password. macOS Recovery installs different versions of macOS, depending on the key combination you use while starting up. Or use Option-Command-R or Shift-Option-Command-R to start up from macOS Recovery over the Internet. Command (⌘)-R: Start up from the built-in macOS Recovery system.Keep holding until the described behavior occurs. To use any of these key combinations, press and hold the keys immediately after pressing the power button to turn on your Mac, or after your Mac begins to restart. Load a command prompt with admin access (Win+X, Command Prompt (Admin)) and type: sc query And scroll for the entry where the DISPLAYNAME is 'TeamViewer 12' and determine what the SERVICENAME is and replace whatever is in the SERVICENAME with 'TeamViewer' in the 'net start' and 'net stop' commands.

Is this possible? If so, can anyone give some information? I have not found it anywhere on Teamviewers support site, and have tried different ways so far.

There is a question on how to start, Teamviewer from commandline, to make outward connections, however I want to start the Teamviewer from commandline (So it can accept incoming connections).Start Teamviewer From Command Line Mac Download.Start Teamviewer From Command Line Mac Address.How can I quit teamviewer via command line and prevent from restarting?! However, it automatically restarts everytime, even after removing the launchctl processes and deleting all teamviewer plist files. I should be able to kill TeamViewer through my ssh tunnel.

Disabled in macOS Mojave or later, or when using a firmware password. To use the default boot image on the server, hold down Option-N instead. N: Start up from a NetBoot server, if your Mac supports network startup volumes.

How to start teamviewer from command line